Re: [openrisc] who can run the uclinux successfully?

[Simon Srot <simons@opencores.org>]

Hi,

The boot is ok. There is no ifconfig and route programs in the ramdisk
image, that is on the CVS (because of the size). These two programs are
executed at the beginning of the shell session, for the network to be
configured. This fails, but you get the prompt, don't you.

	Simon

mtsu wrote:
> Hi
> 
> I make the uclinux step by step by ATS-uclinux script.The result executable file is linux.But put it into or1ksim to run ,the message is following
> 
> OpenRisc 1000 support (C) www.opencores.org
> 
> uClinux/OR32
> 
> Flat model support (C) 1998,1999 Kenneth Albanowski, D. Jeff Dionne
> 
> Calibrating delay loop.. ok - 0.81 BogoMIPS
> 
> Memory available: 7904k/8180k RAM, 0k/0k ROM (284k kernel data, 453k code)
> 
> Swansea University Computer Society NET3.035 for Linux 2.0
> 
> NET3: Unix domain sockets 0.13 for Linux NET3.035.
> 
> uClinux version 2.0.38.1pre3 (oc@fizmo) (gcc version 3.1 20020121 (experimental)) #1 Wed Sep 4 05:25:45 GMT+1 2002
> 
> Serial driver version 4.13p1 with no serial options enabled
> 
> ttyS00 at 0x90000000 (irq = 2) is a 16550A
> 
> Ramdisk driver initialized : 16 ramdisks of 2048K size
> 
> Blkmem copyright 1998,1999 D. Jeff Dionne
> 
> Blkmem copyright 1998 Kenneth Albanowski
> 
> Blkmem 0 disk images:
> 
> RAMDISK: Romfs filesystem found at block 0
> 
> RAMDISK: Loading 215 blocks into ram disk... |/-\|/-\|/-\|/done.
> 
> VFS: Mounted root (romfs filesystem).
> 
> Executing shell ... 
> Shell invoked to run file: /etc/rc
> Command: ifconfig eth0 inet 10.1.1.133 netmask 255.0.0.0 hw ether 00:01:02:03:04:05
> ifconfig: Bad command or file name
> Command: route add -net 10.0.0.0 netmask 255.0.0.0 dev eth0
> route: Bad command or file name
> 
> The result is the same as ATS report.The ATS show the simulation is OK!But I load the test program from or32-uclinux-gdb to or32-uclinux-sim unsuccessfully.I think the uclinux is wrong and boot fail.Who use uclinux OK?and show me the way to solve.Thanks
>
--
To unsubscribe from openrisc mailing list please visit http://www.opencores.org/mailinglists.shtml