Re: [bluetooth] FH Selector implementaion query...

[ccsin@k7mail.com]

Hi all,

I got the results from myself.........(See Below).Hope it will help for someone who are 
interested in the implementation.

Anyway,thank you for attention.


Best Regards

----- Original Message ----- 
From: ccsin@k...  
To: ccsin@k... , bluetooth@o...  
Date: Tue, 13 May 2003 04:46:50 -0100 
Subject: Re: [bluetooth] FH Selector implementaion query... 

> 
> 
> Hi all, 
> 
> I am facing some problem on FH selector. 
> 
> 
> 1.Are Y1 and Y2 1-bit input??If yes,how come the CLK1 * 32 (this 
> might need 6-bit 
> input)? 

Y1 need to be appened to 5-bit.
Y2 is 6-bit based on the multiplication result
> 
> 2. Does the Y1 input need to be appended to 5-bit before xor with 
> input C?? 
> 
>   Example: if Clk1=1, 
>            then Y1 = "11111" xor C 

COrrect!!
> 
> 
> 3. What about the case for Y2, 
>   example: if Clk1 =1 
>            then Y2 = "100000" 
>             Adder2 = E[6:0] + F[6:0] + PERM5_out[4:0] + 6'100000 
> 
>  Is the Y2 input for the Adder2 correct??? 

Correct!!
> 
> Hope someone can help me. 
> 
> Best Regards 
> 
> 
> 
> ----- Original Message ----- 
> From: ccsin@k... 
> To: bluetooth@o... 
> Date: Tue, 6 May 2003 06:41:55 -0100 
> Subject: [bluetooth] FH Selector implementaion query... 
> 
> > 
> > 
> > Hi Jamil,Anilnainwal, 
> > 
> > I got few queries on FH selector implementation,refer to the 
> > "Bluetooth IP core spec" 
> > on section 2.10. 
> > 
> > 1. What is the purpose of the "Valid" port?? 
> > 
> > 2. I suggest to add a "Train" input-port for this block.if 
> train = 
> > 1, offset =24 is 
> > used,however if train = 0,offset = 8 is used.Without this 
> "train" 
> > port,it's hard to 
> > determine what is the offset value to be used and for how long 
> that 
> > according to the 
> > Ninquiry and Npage(since we do not know these Ninq/Npage in 
> this 
> > block).Is my 
> > concept ok??correct me if i'm wrong,since I'm currently 
> > implementing this block. 
> > 
> > 3.Another input-port might be needed,which is "Reset",this 
> reset 
> > can be used to reset 
> > some "Registers" in this block,like "Nreg",which is a counter 
> in 
> > Page and Inquiry 
> > Response. 
> > 
> > 
> > Hope to get Feedback from you ASAP. 
> > 
> > Best Regards, 
> > 
> > Chuan Chew 
> > 
> 
--
To unsubscribe from bluetooth mailing list please visit http://www.opencores.org/mailinglists.shtml