Next: , Previous: Commands, Up: Language



4.3 Types of Commands

Commands in PSPP are divided roughly into six categories:

Utility commands
Set or display various global options that affect PSPP operations. May appear anywhere in a syntax file. See Utility commands.
File definition commands
Give instructions for reading data from text files or from special binary “system files”. Most of these commands replace any previous data or variables with new data or variables. At least one file definition command must appear before the first command in any of the categories below. See Data Input and Output.
Input program commands
Though rarely used, these provide tools for reading data files in arbitrary textual or binary formats. See INPUT PROGRAM.
Transformations
Perform operations on data and write data to output files. Transformations are not carried out until a procedure is executed.
Restricted transformations
Transformations that cannot appear in certain contexts. See Order of Commands, for details.
Procedures
Analyze data, writing results of analyses to the listing file. Cause transformations specified earlier in the file to be performed. In a more general sense, a procedure is any command that causes the active file (the data) to be read.