@table is similar to @itemize, but the command allows
you to specify a name or heading line for each item. (See section Making an Itemized List.) The @table command is used to produce
two-column tables, and is especially useful for glossaries and
explanatory exhibits.
Write the @table command at the beginning of a line and follow
it on the same line with an argument that is a Texinfo command such as
@code, @samp, @var, or @kbd.
Although these commands are usually followed by arguments in braces,
in this case you use the command name without an argument because
@item will supply the argument. This command will be applied
to the text that goes into the first column of each item and
determines how it will be highlighted. For example, @samp
will cause the text in the first column to be highlighted with an
@samp command.
You may also choose to use the @asis command as an argument to
@table. @asis is a command that does nothing; if you use this
command after @table, TeX and the Info formatting commands
output the first column entries without added highlighting (`as
is').
(The @table command may work with other commands besides those
listed here. However, you can only use commands
that normally take arguments in braces.)
Begin each table entry with an @item command at the beginning
of a line. Write the first column text on the same line as the
@item command. Write the second column text on the line
following the @item line and on subsequent lines. (You do not
need to type anything for an empty second column entry.) You may
write as many lines of supporting text as you wish, even several
paragraphs. But only text on the same line as the @item will
be placed in the first column.
Normally, you should put a blank line before an @item line.
This puts a blank like in the Info file. Except when the entries are
very brief, a blank line looks better.
The following table, for example, highlights the text in the first
column with an @samp command:
@table @samp
@item foo
This is the text for
@samp{foo}.
@item bar
Text for @samp{bar}.
@end table
This produces:
If you want to list two or more named items with a single block of
text, use the @itemx command. (See section @itemx.)
Go to the first, previous, next, last section, table of contents.